Simulation and Optimization of Continuous Pig Lift Systems
Notice bibliographique
Résumé
Abstract In a typical gas lift system, slippage between gaseous and liquid phases results in increased water cut and decreased reservoir pressure which reduces lifting efficiency and causes low oil recovery. Pig lift is a novel artificial lift technique proposed in recent years for effectively reducing liquid accumulation and increasing two-phase flow stability in certain special cases, such as high gas-liquid ratio, low reservoir pressure, horizontal and/or rather deep wells, highly viscous or waxy oil, sand production, etc. In this paper, a theoretical study is conducted to simulate the dynamic gas-liquid flow behaviour and optimize the operating parameters of a continuous pig lift system. First, two new flow theories, i.e., non-instantaneous separation and three segment flow, are proposed to simulate the transient two-phase upward flow process during which the pig is launched periodically into the injecting gas. Then, a two-phase flow model, which comprises a set of one-dimensional mass, momentum, energy balance equations, and the equation of state for real gas, is developed to accurately predict gas-liquid flow behaviour in the wellbore. An algorithm to solve this transient flow problem by coupling the gas-liquid flow model and the flow model with the pig is developed and implemented. Finally, a method for the design and optimization of continuous pig lift wells is presented by using nodal system analysis. The detailed simulation results show that, compared with conventional gas lift, pig lift decreases the pressure drop in the wellbore and reduces the slippage loss significantly. The pig launching frequency is the most important parameter in the pig lift system. Increasing the pig launching frequency decreases slippage loss; when the pig launching frequency reaches a certain value, which is the so-called optimal pig launching frequency in this paper, the pressure drop tends towards a non-slippage pressure drop. At the given bottomhole pressure and production rate, the wellhead flow pressure increases with the increase of time, and finally, is close to non-slippage wellhead flow pressure under the optimal pig launching frequency. The gas lift performance curve can be used as an optimization tool to select the optimal operating parameters for the pig lift system. Introduction In a typical gas lift system, gas is continuously or discontinuously injected in the production well to modify the mixture density of producing fluids, decrease the pressure gradient in the liquid and then provide sufficient energy to produce fluid flows. However, during production, the slippage between gaseous and liquid phases results in increased water cut and decreased reservoir pressure, which causes liquid loading, reduces lifting efficiency and causes low oil recovery, especially for some special cases, such as high gas-liquid ratio, low reservoir pressure, horizontal and/or rather deep wells, highly viscous or waxy oil and sand production, etc. Pig lift is a novel gas lift technique proposed by Lima et al.(1) in recent years for effectively reducing liquid accumulation and increasing two-phase flow stability in those cases. They developed a model for the intermittent pig lift system operation and incorporated it into software.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,002 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,000 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule tête enseignante, pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».