Highly Fluorinated Poly(arylene ether ketone) Prepared by a CaH<sub>2</sub>‐Mediated Polycondensation Reaction
Pourquoi ce travail est dans la base
Une base qui oublie comment elle a trouvé un travail ne peut pas être vérifiée. Voici les voies qui ont admis celui-ci.
Notice bibliographique
Résumé
Abstract Summary: A new reaction procedure has been developed for the polycondensation of hexafluorobisphenol A (6F‐BPA) with bis(pentafluorophenyl) ketone (BPK) in dimethylacetamide (DMAc). In this reaction, CaH 2 has been used as a base to facilitate the formation of the phenolate; an alkali metal fluoride was used as a catalyst. Unlike the conventional polycondensation reactions, this procedure avoided producing water during the reaction, and hence, azeotropic distillation with the assistant of a low‐polar co‐solvent is not required. This improvement maintains the high polarity of the reaction medium; consequently, the selectivity of the reaction at the para ‐position of BPK is significantly enhanced and polymers with high molecular weights ( $\overline M _{\rm n}$ ca. 30 000 Da) can be obtained with very low branching contents (less than 3 mol‐%) and free of any cross‐linked gel particles. In addition to avoiding the formation of water in the reaction, the use of CaH 2 also reduced the concentration of the fluoride ion in the solution. These effects minimize chain degradation reactions such as hydrolysis. The use of CaO instead of CaH 2 for this reaction produces similar effects. In the case of CaO, traces of water can be introduced into the reaction. The presence of trace amounts of water increases the polycondensation rate, probably due to the enhanced ionization of the phenolate. However, it also causes a hydrolysis of polymer chains, resulting in the elimination of the ketone group in the polymer backbone. Fortunately, this side reaction is highly water and temperature dependent, and can be efficiently prevented by using CaH 2 or conducting the reaction at a lower temperature (<65 °C). CaH 2 ‐mediated polycondensation for the preparation of highly fluorinated poly(arylene ether ketone). image CaH 2 ‐mediated polycondensation for the preparation of highly fluorinated poly(arylene ether ketone).
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,000 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle