MétaCan
Menu
Retour à la cohorte
Enregistrement W2025875567 · doi:10.1159/000046675

Comparison between Tinzaparin and Standard Heparin for Chronic Hemodialysis in a Canadian Center

2002· article· en· W2025875567 sur OpenAlex

Pourquoi ce travail est dans la base

Une base qui oublie comment elle a trouvé un travail ne peut pas être vérifiée. Voici les voies qui ont admis celui-ci.

affAu moins un auteur déclare une institution canadienne dans l'instantané OpenAlex épinglé.
aboutLe titre ou le résumé porte un signal canadien du lexique géographique.

Notice bibliographique

RevueAmerican Journal of Nephrology · 2002
Typearticle
Langueen
DomaineHealth Professions
ThématiqueCentral Venous Catheters and Hemodialysis
Établissements canadiensUniversité de MontréalHôpital Maisonneuve-Rosemont
Organismes subventionnairesnon disponible
Mots-clésMedicineHemodialysisHeparinActivated clotting timeBolus (digestion)Low molecular weight heparinExtracorporealSurgeryThrombosisAnesthesia

Résumé

récupéré en direct d'OpenAlex

BACKGROUND: Low-molecular-weight heparins offer several advantages over standard heparins, but their use for maintenance hemodialysis has been limited in North America because of their higher cost. Our objective was to compare tinzaparin to standard heparin during maintenance hemodialysis over an 8-week period, in regard to the visual aspect of the extracorporeal circuit, filter reuse, bleeding and time for compression of vascular access at the end of hemodialysis session, nursing time devoted to anticoagulation administration, level of satisfaction of patients and nurses, and relative cost. METHODS: Thirty-two chronic hemodialysis adult patients with peripheral accesses were randomly divided into two groups in a cross-over design: tinzaparin for 4 weeks followed by standard heparin for 4 weeks, or vice versa. Hemodialysis was performed thrice weekly over 3.5-4 h using large surface reused filters. Standard heparin was administered as an initial bolus of 50-75 units per kilogram followed by an infusion to maintain an activated clotting time (ACTESTER) between 150 and 200 s and discontinued 30-45 min before the end of the session. The initial dose of tinzaparin was 3,500 IU anti-Xa for patients usually receiving 7,500 units or less of standard heparin, or 4,500 IU anti-Xa for patients receiving more than 7,500 units of standard heparin, and it was injected as a bolus in the arterial line at the beginning of hemodialysis. Dosage adjustments were made by increments or decrements of 500 IU. RESULTS: A total of 6 patients did not require any adjustment in their dose of tinzaparin and remained at the initial dose, while the remaining 26 necessitated adjustments of the initial dose of tinzaparin: 20 patients required increments from the initial dose whereas 6 required reductions. For most patients, 27 of them, the standard heparin dose was kept at the same level throughout the study period (since it was their usual regimen and they were in stable medical conditions). According to the monitoring scale, the visual aspects of the tubing of the extracorporeal circuit and of the dialyzers at the end of the session were similar for both tinzaparin and standard heparin. The time of compression of the vascular access at the end of the hemodialysis sessions was not significantly different with tinzaparin than with standard heparin. However, as indicated below, most patients noted less bleeding (or oozing) from their access (during compression and thereafter, in the few hours after hemodialysis) with tinzaparin than with standard heparin. Clotting was observed more frequently in the arterial and venous bubble traps with tinzaparin than with standard heparin. The presence of clot(s) was observed in the arterial and venous bubble traps in, respectively, 18 +/- 12 and 10 +/- 6% of the sessions with tinzaparin, while in, respectively, 3 +/- 4 and 2 +/- 4% of the sessions with standard heparin (p < 0.005). Despite a tendency for a reduced reuse number of the dialyzers, the difference did not reach statistical significance. Among the 30 patients who completed the study, 2 reported excessive bleeding from their vascular access with tinzaparin whereas 8 reported such an excessive bleeding with standard heparin. The level of satisfaction of patients and nurses for tinzaparin was extremely good. The main reasons stated by the patients was reduced bleeding from their access after dialysis. The nurses preferred tinzaparin because of the simplicity and the rapidity of its administration, the lack of monitoring required, and the decreased bleeding/oozing tendency from the vascular access sites. The time spent for anticoagulation during a hemodialysis session was reported as 5 min with standard heparin (if no ACTESTER monitoring), 25-30 min with standard heparin (if ACTESTER monitoring required), and 1 min with tinzaparin. The cost analysis revealed that although tinzaparin is more than six times more expensive than standard heparin, the use of tinzaparin becomes similar to the use of standard heparin (USD 7.33 vs. USD 7.62 Canadian dollars for one hemodialysis session) if ACTESTER monitoring is performed (assuming that 22% of the sessions are routinely monitored and that one ACTESTER device is necessary for 8-10 dialysis stations, as applied in our unit). CONCLUSION: Our experience with tinzaparin was positive: it represents a simple and easy way to offer anticoagulation during maintenance hemodialysis, it seems associated with less postdialysis bleeding, it saves precious nursing time and is widely appreciated by patients and staff.

Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.

Prédiction distillée sur la base complète

Imitation des enseignants

Ni prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.

score de la tête « metaresearch » (Codex)0,001
score de la tête « metaresearch » (Gemma)0,000
Version: codex-gemma-dda1882f352aStatut de validation: machine_predicted_unvalidated
Catégories candidatesaucune
Catégories consensuellesaucune
DomaineSignal candidat: aucune · Signal consensuel: aucune
Devis d'étudeSignal candidat: Observationnel · Signal consensuel: aucune
GenreSignal candidat: Empirique · Signal consensuel: Empirique
Score de désaccord entre enseignants0,617
Score d'incertitude au seuil0,956

Scores Codex et Gemma par catégorie

CatégorieCodexGemma
Métarecherche0,0010,000
Méta-épidémiologie (sens strict)0,0000,000
Méta-épidémiologie (sens large)0,0010,000
Bibliométrie0,0000,000
Études des sciences et des technologies0,0000,000
Communication savante0,0000,000
Science ouverte0,0000,000
Intégrité de la recherche0,0000,001
Charge utile insuffisante (le modèle a refusé de juger)0,0000,000

Scores machine (provisoires)

Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.

Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.

Tête enseignante Opus0,042
Tête enseignante GPT0,366
Écart entre enseignants0,323 · la distance entre les deux têtes enseignantes sur ce seul travail
Statut de validationscore_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle