Design and Installation of a Push Water System for Transport of Senlac Early Well Life Produced Fluids
Notice bibliographique
Résumé
Abstract Senlac/Winter horizontal well performance is characterized by a short period of high-oil-cut production followed by water cut increases over a several month period to very high water cuts. Previously, the more viscous high-oil-cut fluids have typically been trucked to more distant treating facilities, while the subsequent high-water-cut fluids have been pipelined. This project was initiated to field test the feasibility of a novel method of transporting early life high-oil-cut fluids using high-water-cut fluids from mature wells as the push water, thereby reducing capital costs, operating costs, and environmental risk. The push water system worked well, indicating that Senlac area development can be considered for areas more distant from facilities. Further, when the produced water cuts increased sufficiently to be pipelined without push water, the push water source line was reversed and is now being used to enhance the capacity to carry produced fluids from the new well area to the treating facilities. This paper discusses the design and operation of the push water system. Also discussed is the phenomenon of core annular flow of heavy oil/produced water mixtures, which may be spontaneously occurring at the conditions in the Senlac Push Line. Introduction Problem: Transport of Early Well Life High- Oil-Cut Produced Fluids Viscous high-oil-cut fluids produced during the early life of outlying Senlac/Winter area Dina/Cummings formation horizontal wells have typically been transported to batteries using trucks. This fluid transport method requires:construction of a tank farm with secondary containment, fuel, and flaring;increased requirements for lease road construction and maintenance; and,associated increased truck traffic and dust. When two new well pads were drilled 6.45 km from the closest battery, the decision was made to evaluate alternate methods of transportation. One option under consideration was the construction of satellite batteries and water disposal facilities near the new well pads, which would result in the shipment of relatively dry oil. A second option was the installation of a larger 273.1 mm OD (10-in nominal) pipeline to be operated during the high-oil-cut period by mixing diluent with the produced oil. The third option to trucking was the construction of a pipeline system using produced fluids from mature wells as push water during the early high-oilcut period of the new pad wells. Economic Comparison of Transportation Options Incentive for the dual push water system was determined by the higher cost and environmental impacts associated with the three available alternative methods of transporting produced fluids during the early well life low-water-cut period seen at Senlac wells. For this project, direct trucking costs were estimated by multiplying the number of new wells (16) by the expected m3/d of production by the trucking cost/m3 by the number of days trucking would be required. The estimated cost is 16 wells ??40 m3/d/well ??$4.60/m3 shipped by 365 days × 0.95 availability factor = $1 MM.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction machine sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Le volet Gemma est une étiquette directe du modèle pour chaque travail de la base, lue sur la notice réduite au titre. Le volet Codex est un classifieur appris des 10 348 étiquettes directes de Codex et calibré sur les taux pondérés de l'échantillon; les champs sans appui suffisant ne portent aucun appel Codex. Le mode candidate est l'union des deux volets; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont pas des étiquettes humaines.
Scores du classifieur distillé par catégorie (deux têtes)
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,001 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,001 | 0,000 |
| Études des sciences et des technologies | 0,001 | 0,000 |
| Communication savante | 0,001 | 0,001 |
| Science ouverte | 0,001 | 0,001 |
| Intégrité de la recherche | 0,001 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,002 | 0,001 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule source (Gemma direct ou Codex distillé), pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».