Notice bibliographique
Résumé
This article, written by Assistant Technology Editor Karen Bybee, contains highlights of paper SPE 112368, "Tar Sands Drilling Waste Management: A Clean Solution," by C. Nilsen, SPE, K. McCosh, SPE, and M. Kapila, SPE, M-I SWACO, originally prepared for the 2008 IADC/SPE Drilling Conference, Orlando, Florida, 4-6 March. The paper has not been peer reviewed. The full-length paper presents novel technology for treatment of tar-sands drilling waste generated from steam-assisted gravity drainage (SAGD) and other tar-sands drilling operations. The continuous treatment process is based on hot-water addition, mixing, and separation techniques to reduce the viscosity and specific gravity of the bitumen to separate it from the sand. Treatment of cuttings with light to heavy bitumen contamination has shown this treatment method to be a simple and effective means of producing clean sand and recovering the bitumen component. Introduction Tar sands are sandstone formations saturated with bitumen or heavy oil. The sandstone is thought to remain water-wet in the formation and can be unconsolidated, with the sand grains held together mainly by the bitumen. Alternatively, the sandstone can be consolidated, with silica or carbonate cement holding the sand together and bitumen filling the remaining voids. The bitumen deposits were formed in the geological past from crude oil that migrated to the surface of the Earth. Weathering and chemical and biological processes resulted in loss of the light fractions, leaving behind the very-viscous, solid or semisolid heavy fractions. Typically, bitumen has a density greater than 960 kg/m3. Over the millennia, weather and geologic action covered the semisolid bitumen with layers of soil, and today, most bitumen and heavy-oil production comes from deposits buried more than 400 m below the surface of the Earth. Bitumen deposits are found in more than 70 countries worldwide, but 75% occur in Canada and Venezuela. In Canada, most of the oil sands are located in three major areas in northern Alberta, which hold at least 175 billion bbl of recoverable bitumen. Where the heavy oil is thin it can be pumped out of the sands with progressing-cavity pumps (PCPs). To increase recovery, cold heavy-oil production with sand also is used in which sand is encouraged to enter the well by aggressive perforation and swabbing strategies. Removal of the sand with the heavy oil increases the formation permeability, expands the high-permeability zone as sand is produced, and prevents plugging of the near-wellbore region by asphaltenes or fines.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,001 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,000 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule tête enseignante, pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».