Degradation of Mechanical Properties for Polyethylene by Small-Deformation Damage
Notice bibliographique
Résumé
Polyethylene (PE) has now been widely used to make plastic pipe for gas transportation. Because of its excellent ductility, processes for repair and maintenance of PE pipe allow squeeze-flattening the pipe to reduce the gas flow. Our previous study has shown that stretch of PE, even at a low strain level, can cause damage of the material, and significance of the damage depends on the strain rate. This paper presents results from a follow-up study, to investigate the possibility of quantifying the influence of damage on the mechanical properties. Coupon specimens used in this study have the same geometry as that used previously. Each specimen was tested twice. The 1st test was to introduce the damage, by stretching the specimen at a crosshead speed of 1 mm/min; the 2nd test to characterize the influence of the damage on the mechanical properties, by stretching the specimen at 1 μm/min. The two crosshead speeds were chosen because the former (1 mm/min) is known to introduce much more damage than the latter (1 μm/min) at a same strain level. Therefore, change in mechanical properties observed from the 2nd test should mainly come from the damage generated in the 1st test. To avoid influence of viscous recovery from the 1st test on the results from the 2nd test, the two tests were conducted more than one month apart. Test results show that even by stretching the specimen to a strain level below the yield point in the 1st test (i.e. with the strain less than 0.1), damage introduced to the specimen can cause a detectable decrease in the mechanical properties, such as the tangent modulus at the strain 0.01 and the stress response at the strain 0.1, from the 2nd test. The results also show that the rate of decrease of the above values with the increase of strain becomes significant when the strain level introduced in the 1st test is above the yield point. By stretching the specimen to a strain level about 0.5 in the 1st test, though yet to cause apparent necking or stress whitening, the tangent modulus and the stress response in the 2nd test are decreased by about one-third of the values for the virgin specimen. This amount of change is significant and should not be ignored for long-term applications such as for gas transportation.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction machine sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Le volet Gemma est une étiquette directe du modèle pour chaque travail de la base, lue sur la notice réduite au titre. Le volet Codex est un classifieur appris des 10 348 étiquettes directes de Codex et calibré sur les taux pondérés de l'échantillon; les champs sans appui suffisant ne portent aucun appel Codex. Le mode candidate est l'union des deux volets; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont pas des étiquettes humaines.
Scores du classifieur distillé par catégorie (deux têtes)
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,001 | 0,001 |
| Méta-épidémiologie (sens strict) | 0,001 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,001 | 0,001 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,001 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,001 | 0,001 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,002 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule source (Gemma direct ou Codex distillé), pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».