MétaCan
Menu
Retour à la cohorte
Enregistrement W2325046087 · doi:10.1021/am300487c

Hydroxyapatite Formation on Sol–Gel Derived Poly(ε-Caprolactone)/Bioactive Glass Hybrid Biomaterials

2012· article· en· W2325046087 sur OpenAlexafffund
Bedilu Allo, Amin S. Rizkalla, Kibret Mequanint

Notice bibliographique

RevueACS Applied Materials & Interfaces · 2012
Typearticle
Langueen
DomaineEngineering
ThématiqueBone Tissue Engineering Materials
Établissements canadiensWestern University
Organismes subventionnairesNatural Sciences and Engineering Research Council of CanadaCanadian Institutes of Health Research
Mots-clésSimulated body fluidBiocompatibilityMaterials scienceBioactive glassApatiteCaprolactoneFourier transform infrared spectroscopyChemical engineeringScanning electron microscopeNuclear chemistryContact angleComposite materialCopolymerPolymerChemistry

Résumé

récupéré en direct d'OpenAlex

Investigation of novel biomaterials for bone regeneration is based on the development of scaffolds that exhibit bone-bonding ability, biocompatibility, and sufficient mechanical strength. In this study, using novel poly (ε-caprolactone)/bioactive glass (PCL/BG) hybrids with different organic/inorganic ratios, the effects of BG contents on the in vitro bone-like hydroxyapatite (HA) formation, mechanical properties, and biocompatibility were investigated. Rapid precipitation of HA on the PCL/BG hybrid surfaces were observed after incubating in simulated body fluid (SBF) for only 6 h, as confirmed by scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDX), Fourier-transform infrared spectroscopy (FTIR), and inductively coupled plasma atomic emission spectroscopy (ICPS). The ICPS elemental analysis results were further analyzed in terms of the Ca(2+) and PO4(3-) which were consumed to form the apatite layer. The results revealed that the rate and total amount of HA deposition decreased with an increase in PCL content. The compressive modulus and strength of the PCL/BG hybrids increased with the decrease in PCL content. The highest values were achieved at the lowest PCL content (10 wt %) and were around, 90 MPa and 1.4 GPa, respectively. To evaluate the cytotoxicity of PCL/BG bioactive hybrids, MC3T3-E1 osteoblast-like cells were cultured for up to 72 h. Our data indicated that whereas initial cell attachment was marginally lower than the control tissue culture poly styrene (TCPS) surface, the hybrid materials promoted cell growth in a time-dependent manner. Cell viability within the different PCL/BG hybrid samples appeared to be influenced by compositional differences whereby higher PCL contents correlated with slight reduction in cell viability. Taken together, this study adds important new information to our knowledge on hydroxyapatite formation, mechanical properties, and cytotoxic effects of PCL/BG hybrids prepared by the sol-gel process using a tertiary glass composition and may have considerable potential for bone tissue regeneration applications.

Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.

Comment cette classification a été obtenuedéplier

Prédiction distillée sur la base complète

Imitation des enseignants

Ni prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.

score de la tête « metaresearch » (Codex)0,001
score de la tête « metaresearch » (Gemma)0,000
Version: codex-gemma-dda1882f352aStatut de validation: machine_predicted_unvalidated
Catégories candidatesMéta-épidémiologie (sens strict), Charge utile insuffisante (le modèle a refusé de juger)
Catégories consensuellesaucune
DomaineSignal candidat: aucune · Signal consensuel: aucune
Devis d'étudeSignal candidat: Expérimental (laboratoire) · Signal consensuel: Expérimental (laboratoire)
GenreSignal candidat: Empirique · Signal consensuel: Empirique
Score de désaccord entre enseignants0,007
Score d'incertitude au seuil1,000

Scores Codex et Gemma par catégorie

CatégorieCodexGemma
Métarecherche0,0010,000
Méta-épidémiologie (sens strict)0,0010,001
Méta-épidémiologie (sens large)0,0010,000
Bibliométrie0,0000,000
Études des sciences et des technologies0,0000,000
Communication savante0,0000,001
Science ouverte0,0000,000
Intégrité de la recherche0,0000,000
Charge utile insuffisante (le modèle a refusé de juger)0,0010,002

Scores machine (provisoires)

Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.

Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.

Tête enseignante Opus0,012
Tête enseignante GPT0,213
Écart entre enseignants0,201 · la distance entre les deux têtes enseignantes sur ce seul travail
Statut de validationscore_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle

Classification

machine, non validée

Prédiction automatique; un appel candidat d’une seule tête enseignante, pas un consensus.

Devis d'étudeExpérimental (laboratoire)
Domainenon disponible
GenreEmpirique

Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».

En bref

Citations62
Publié2012
Routes d'admission2
Résumé présentoui

Explorer davantage

Même revueACS Applied Materials & InterfacesMême sujetBone Tissue Engineering MaterialsTravaux en français237 207