Application of Low Salinity Micellar Emulsion In Chemical EOR of Heavy Oil
Notice bibliographique
Résumé
Abstract In phase behavior studies of conventional oil for chemical EOR, formation of a single phase homogeneous emulsion system can be achieved only with formulations containing relatively high concentrations of synthetic surfactant. Application of the single phase micellar emulsion in chemical EOR has not been successful economically due to high cost of surfactant and surfactant loss in the reservoir. The economic picture could be much better when this technology is applied for recovery of high TAN heavy oils which can release the required amount of surfactant (petroleum soap) in-situ upon contact with the ASP solution. This paper describes the successful formulation of an ASP system which can generate a single phase (Winsor type IV) micellar emulsion when mixed with a viscous high TAN (2.0 mg KOH/g) heavy oil. This ASP system contains commercial HPAM and NaOH in low salinity water. The micellar emulsion system, which is thermodynamically stable under very low salinity conditions, can contain as much as 33% of crude oil before transition to a Winsor type I system with a separate excess oil phase. Viscosity of the oil-in-water micellar emulsion varies with its oil content and is generally much less than 1/10 of the parent crude oil. The petroleum acid, which is a key component in the formation of the micellar emulsion, has been successfully isolated from the crude oil. Analytical results of the acid, by means of FTIR, NMR, LC-mass-spectroscopy and elemental analysis, will be presented. The effectiveness of this ASP system in mobilization of capillary trapped heavy oil has been demonstrated with a Berea coreflood test. To ensure that adequate mobility control was present during displacement of the viscous heavy oil, separate sand-pack tests were also conducted for selection of candidate ASP solutions based on in-situ resistance factors. As a result, excellent incremental oil recovery (67% OOIP) and outstanding production rate (30% OOIP in 1 PV) were achieved during displacement of the viscous heavy oil (10,000 mPa.s) from Berea core. Residual oil saturation of the post-test core was < 7% Pore Volume. To our knowledge, application of micellar emulsion generated from natural petroleum soap in chemical EOR of heavy oil has not been investigated extensively. Results from this study can lead to better understanding and improvement of this chemical EOR technology for heavy oil.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction machine sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Le volet Gemma est une étiquette directe du modèle pour chaque travail de la base, lue sur la notice réduite au titre. Le volet Codex est un classifieur appris des 10 348 étiquettes directes de Codex et calibré sur les taux pondérés de l'échantillon; les champs sans appui suffisant ne portent aucun appel Codex. Le mode candidate est l'union des deux volets; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont pas des étiquettes humaines.
Scores du classifieur distillé par catégorie (deux têtes)
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,001 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule source (Gemma direct ou Codex distillé), pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».