A fully integrated pulse charge generator embedded in a 64-channel readout ASIC dedicated to a PET/CT detector module
Notice bibliographique
Résumé
The LabPET <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">TM</sup> II is a new Positron Emission Tomography/Computed Tomography (PET/CT) scanner dedicated to small animals imaging under development at the Université de Sherbrooke. Its design requires nearly 37 000 detectors spread over a ring of 15 cm in diameter and 12 cm of axial length. This new scanner will break the submillimetric spatial resolution barrier in PET mode thanks to a new double 4 × 8 array of 1.1 × 1.1 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> avalanche photodiode (APD) coupled to an 8 × 8 LYSO crystal matrix. In order to readout individually each pixel of this detector block, a 64-channel Application Specified Integrated Circuit (ASIC) was developed based on Time-over-Threshold (ToT) technique. The ToT computations allow the extraction of both the energy and time of occurrence of PET signals. There are also adjustable gains located in each individual analog front-end chain that enables the detection of low energy X-ray photons (~ 42 keV) required for CT imaging mode. As a result of the complexity of this fully mixed-signal chip, calibrating the scanner and testing every single channel can be a cumbersome job on PCB using an external charge injector equipment. To facilitate those operations, a fully integrated pulse charge generator (PCG) was designed for the LabPET™ II ASIC. The PCG injects a 3-bit adjustable amount of charge in each channel in order to verify their impulse response and to calculate intrinsic energy and time resolution for both PET and CT modes. It can also be used to evaluate the analog front-end electronics noise, by knowing the electronic gain of each channel individually. The PCG can inject a charge that ranges from 35 fC to 56 fC by steps of 2.6 fC in PET mode and from 2.3 fC to 5.1 fC in steps of 0.3 fC at a rate of 1 kHz.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,001 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,002 | 0,001 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; les deux têtes enseignantes s’accordent sur ce qui est montré ici.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».