MétaCan
Menu
Retour à la cohorte
Enregistrement W2583517485 · doi:10.4271/2017-01-0464

Load and Lubricating Oil Effects on Friction of a PEO Coating at Different Sliding Velocities

2017· article· en· W2583517485 sur OpenAlexafffund
Guang Wang, Xueyuan Nie, Jimi Tjong

Notice bibliographique

RevueSAE technical papers on CD-ROM/SAE technical paper series · 2017
Typearticle
Langueen
DomaineEngineering
ThématiqueTribology and Wear Analysis
Établissements canadiensUniversity of Windsor
Organismes subventionnairesNatural Sciences and Engineering Research Council of Canada
Mots-clésCoatingMaterials scienceComposite materialPetroleum engineeringGeology

Résumé

récupéré en direct d'OpenAlex

<div class="section abstract"><div class="htmlview paragraph">Friction between the piston and cylinder accounts for large amount of the friction losses in an internal combustion (IC) engine. Therefore, any effort to minimize such a friction will also result in higher efficiency, lower fuel consumption and reduced emissions. Plasma electrolytic oxidation (PEO) coating is considered as a hard ceramic coating which can provide a dimpled surface for oil retention to bear the wear and reduce the friction from sliding piston rings. In this work, a high speed pin-on-disc tribometer was used to generate the boundary, mixed and hydrodynamic lubrication regimes. Five different lubricating oils and two different loads were applied to do the tribotests and the COFs of a PEO coating were studied. The results show that the PEO coating indeed had a lower COF in a lower viscosity lubricating oil, and a smaller load was beneficial to form the mixed and hydrodynamic lubricating regimes earlier. The wear scar sizes on counterpart materials were, to some degree, increased with the decrease of oil viscosities at both test loads. It suggests that the benefit of a lower friction (thus, a presumably less wear) induced from a lower viscosity oil couldn’t overweigh a potential concern of wear occurred for a thinner oil. When tested with a very high viscosity of oil, the counterpart material had a significantly less wear, which may indicate that such kind of oil would provide a piston ring with a better protection against the ceramic coating. Thus, a proper selection of lubricating oil for PEO coating would be a decisive factor for balance between reducing friction loss and piston ring wear in an IC engine. The tests were carried out only at a room temperature (~20°C), high temperature tests and floating liner engine dynamometer tests should be done in the future for validation of the benefit of a PEO coating.</div></div>

Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.

Comment cette classification a été obtenuedéplier

Prédiction distillée sur la base complète

Imitation des enseignants

Ni prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.

score de la tête « metaresearch » (Codex)0,000
score de la tête « metaresearch » (Gemma)0,001
Version: codex-gemma-dda1882f352aStatut de validation: machine_predicted_unvalidated
Catégories candidatesMéta-épidémiologie (sens strict)
Catégories consensuellesaucune
DomaineSignal candidat: aucune · Signal consensuel: aucune
Devis d'étudeSignal candidat: Expérimental (laboratoire) · Signal consensuel: aucune
GenreSignal candidat: Empirique · Signal consensuel: Empirique
Score de désaccord entre enseignants0,985
Score d'incertitude au seuil1,000

Scores Codex et Gemma par catégorie

CatégorieCodexGemma
Métarecherche0,0000,001
Méta-épidémiologie (sens strict)0,0010,000
Méta-épidémiologie (sens large)0,0010,000
Bibliométrie0,0000,000
Études des sciences et des technologies0,0010,001
Communication savante0,0000,000
Science ouverte0,0010,000
Intégrité de la recherche0,0010,001
Charge utile insuffisante (le modèle a refusé de juger)0,0000,000

Scores machine (provisoires)

Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.

Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.

Tête enseignante Opus0,010
Tête enseignante GPT0,229
Écart entre enseignants0,219 · la distance entre les deux têtes enseignantes sur ce seul travail
Statut de validationscore_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle

Classification

machine, non validée

Prédiction automatique; un appel candidat d’une seule tête enseignante, pas un consensus.

Devis d'étudeExpérimental (laboratoire)
Domainenon disponible
GenreEmpirique

Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».

En bref

Citations1
Publié2017
Routes d'admission2
Résumé présentoui

Explorer davantage

Même revueSAE technical papers on CD-ROM/SAE technical paper seriesMême sujetTribology and Wear AnalysisTravaux en français237 207