Transient Heat Transfer in an Out-of-Pile SCWR Fuel Assembly Test at Near-Critical Pressure
Notice bibliographique
Résumé
While supercritical water is a perfect coolant with excellent heat transfer, a temporary decrease of the system pressure to subcritical conditions, either during intended transients or by accident, can easily cause a boiling crisis with significantly higher cladding temperatures of the fuel assemblies. These conditions have been tested in an out-of-pile experiment with a bundle of four heated rods in the supercritical water multipurpose loop (SWAMUP) facility coconstructed by CGNPC and SJTU in China. Some of the transient tests have been simulated at KIT with a one-dimensional (1D) matlab code, assuming quasi-steady-state flow conditions, but time dependent temperatures in the fuel rods. Heat transfer at supercritical and at near-critical conditions was modeled with a recent look-up table of Zahlan (2015, “Derivation of a Look-Up Table for Trans-Critical Heat Transfer in Water Cooled Tubes,” Ph.D. dissertation, University of Ottawa, Ottawa, ON, Canada.), and subcritical film boiling was modeled with the look-up table of Groeneveld et al. (2003, “A Look-Up Table for Fully Developed Film Boiling Heat Transfer,” Nucl. Eng. Des., 225(1), pp. 83–97.). Moreover, a conduction controlled rewetting process was included in the analyses, which is based on an analytical solution of Schulenberg and Raqué (2014, “Transient Heat Transfer During Depressurization From Supercritical Pressure,” Int. J. Heat Mass Transfer, 79(12), pp. 233–240.). The method could well reproduce the boiling crisis during depressurization from supercritical to subcritical pressure, including rewetting of the hot zone within some minutes, but the peak temperature was somewhat under-predicted. Tests with a lower heat flux, which did not cause such phenomena, could be predicted as well. In another test with increasing pressure, however, a boiling crisis was also observed at a heat flux, which was significantly lower than the critical heat flux (CHF) predicted by the CHF look-up table of Groeneveld et al. (2007, “The 2006 CHF Look-Up Table,” Nucl. Eng. Des., 237(15–17), pp. 1909–1922.). The paper is summarizing the physical models and the numerical approach. Comparison with experimental data is used to discuss the applicability of the method for the design of supercritical water-cooled reactors (SCWR).
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction machine sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Le volet Gemma est une étiquette directe du modèle pour chaque travail de la base, lue sur la notice réduite au titre. Le volet Codex est un classifieur appris des 10 348 étiquettes directes de Codex et calibré sur les taux pondérés de l'échantillon; les champs sans appui suffisant ne portent aucun appel Codex. Le mode candidate est l'union des deux volets; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont pas des étiquettes humaines.
Scores du classifieur distillé par catégorie (deux têtes)
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,001 |
| Méta-épidémiologie (sens strict) | 0,001 | 0,000 |
| Méta-épidémiologie (sens large) | 0,001 | 0,001 |
| Bibliométrie | 0,001 | 0,000 |
| Études des sciences et des technologies | 0,001 | 0,000 |
| Communication savante | 0,000 | 0,001 |
| Science ouverte | 0,001 | 0,001 |
| Intégrité de la recherche | 0,001 | 0,001 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,003 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule source (Gemma direct ou Codex distillé), pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».