Control of composite thin film made in an Ar/isopropanol/TiO<sub>2</sub> nanoparticles dielectric barrier discharge by the excitation frequency
Pourquoi ce travail est dans la base
Une base qui oublie comment elle a trouvé un travail ne peut pas être vérifiée. Voici les voies qui ont admis celui-ci.
Notice bibliographique
Résumé
The synthesis of composites thin films made by injecting an aerosol suspension of 20 nm‐size TiO 2 nanoparticles (NPs) and isopropanol (IPA) in a filamentary argon Dielectric Barrier Discharge (DBD) is studied as a function of the DBD frequency from 1 to 50 kHz. The plasma is modulated to get homogeneous coatings. The deposition rate and morphology of the composite thin films are determined from SEM images of both surface and cross section. Their chemical composition is investigated by XPS, Raman spectroscopy and FTIR measurements. The structural composition of the NPs is examined by XRD. All the deposited composites show the chemical signature of the NPs as well as of the polymer‐like coating resulting from the plasma polymerization of IPA. No mixed phase is observed and the sizes of the NPs as well as of their aggregates are not affected by the plasma. With this method aerosol droplets are evaporated before entering the plasma and the NPs inside a same droplet are aggregated. Results show that the DBD frequency controls the composite composition by independently influencing the NPs transport and the matrix growth rate. At 1 kHz, the coating is essentially made of NPs with a low carbon coating. From 1 to 50 kHz, the Ti/C ratio is divided by two orders of magnitude. As the frequency increases the quantity of NPs decreases and since 10 kHz the matrix thickness increases. The decrease of the NPs is explained by the numerical modeling of the NPs trajectory. It is found that from 10 to 1 kHz, the lower is the frequency, the higher is the transport of the NPs to the surface due to the electrostatic force. On the other hand the matrix growth rate increases from almost zero at 10 kHz up to 19 nm · min −1 at 50 kHz because of the linear increases of the DBD power with the frequency.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,000 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle