MétaCan
Menu
Retour à la cohorte
Enregistrement W4385392005 · doi:10.2172/1992648

FY 2016 Progress Report on the ANL Sodium Draining and Refilling Experiments

2016· report· en· W4385392005 sur OpenAlexaff
David Chojnowski, E. Boron, J.J. Sienicki, Dennis Kildonk, C. B. Reed

Notice bibliographique

Revuenon disponible
Typereport
Langueen
DomaineEngineering
ThématiqueThermodynamic and Structural Properties of Metals and Alloys
Établissements canadiensCascades (Canada)
Organismes subventionnairesArgonne National LaboratoryUniversity of ChicagoU.S. Department of Energy
Mots-clésSodiumSodium-cooled fast reactorDecay heatHeat exchangerSodium channelChemistryMaterials scienceWaste managementNuclear chemistryThermodynamicsMetallurgyEngineeringPhysics

Résumé

récupéré en direct d'OpenAlex

The main incentive for utilization of compact diffusion-bonded sodium-to-CO<sub>2</sub> heat exchangers for a Sodium-Cooled Fast Reactor (SFR) with a supercritical carbon dioxide (sCO<sub>2</sub>) Brayton cycle power converter is the potential for reduction in heat exchanger size and cost relative to traditional shell-and-tube technology. There is an incentive for the designer to reduce the width of the sodium and CO<sub>2</sub> channels as much as possible to realize the greatest size and cost reductions. However, there are practical limits on minimum channel size due to fundamental phenomena particular to sodium and CO<sub>2</sub>. One is that the channel size must be large enough to enable the rapid draining of sodium from the heat exchanger sodium channels in the event that a sodium leak is detected in an intermediate sodium heat transport system loop, in order to rapidly drain the sodium into the loop sodium storage vessel/tank and thereby limit the sodium mass released that could potentially burn if exposed to air. Information about the minimum sodium channel size can only be obtained by actually draining sodium from representative stainless steel sodium channels under prototypical conditions. It is not possible to obtain such information through modeling and simulation or through simulant experiments. The ANL Sodium Draining and Refilling experiment facility has been designed and is being assembled to obtain data on the draining of sodium from compact diffusion bonded sodium-to-carbon dioxide heat exchanger sodium channels including the mass of sodium drained versus time, the mass of sodium retained inside of the channels, and the potential for sodium to bridge the channel, freeze, and form a plug inside the channel versus the channel size. This information is needed to determine the minimum sodium channel size required to meet the requirements for sodium draining without bridges being left inside of the channels. Initial shakedown testing has been initiated using water and glass tubes before transitioning to sodium and stainless steel test sections. For the latter, the test sections will be heated to promote rapid sodium wetting of the stainless steel prior to draining. Testing with sodium will be initiated in FY 2017.

Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.

Comment cette classification a été obtenuedéplier

Prédiction distillée sur la base complète

Imitation des enseignants

Ni prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.

score de la tête « metaresearch » (Codex)0,000
score de la tête « metaresearch » (Gemma)0,000
Version: codex-gemma-dda1882f352aStatut de validation: machine_predicted_unvalidated
Catégories candidatesaucune
Catégories consensuellesaucune
DomaineSignal candidat: aucune · Signal consensuel: aucune
Devis d'étudeSignal candidat: Sans objet · Signal consensuel: aucune
GenreSignal candidat: Empirique · Signal consensuel: aucune
Score de désaccord entre enseignants0,789
Score d'incertitude au seuil0,729

Scores Codex et Gemma par catégorie

CatégorieCodexGemma
Métarecherche0,0000,000
Méta-épidémiologie (sens strict)0,0000,000
Méta-épidémiologie (sens large)0,0000,000
Bibliométrie0,0000,000
Études des sciences et des technologies0,0000,000
Communication savante0,0000,000
Science ouverte0,0000,000
Intégrité de la recherche0,0000,000
Charge utile insuffisante (le modèle a refusé de juger)0,0000,000

Scores machine (provisoires)

Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.

Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.

Tête enseignante Opus0,038
Tête enseignante GPT0,263
Écart entre enseignants0,225 · la distance entre les deux têtes enseignantes sur ce seul travail
Statut de validationscore_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle

Classification

machine, non validée

Prédiction automatique; un appel candidat d’une seule tête enseignante, pas un consensus.

Les modèles n’ont appliqué aucune catégorie : rien dans la taxonomie ne correspondait à ce travail.
Devis d'étudeSans objet
Domainenon disponible
GenreEmpirique

Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».

En bref

Citations0
Publié2016
Routes d'admission1
Résumé présentoui

Explorer davantage

Même sujetThermodynamic and Structural Properties of Metals and AlloysTravaux en français237 207