Measurements of heat flux components due to charged and non-charged particles in DIII-D divertor near and under detachment
Pourquoi ce travail est dans la base
Une base qui oublie comment elle a trouvé un travail ne peut pas être vérifiée. Voici les voies qui ont admis celui-ci.
Notice bibliographique
Résumé
• SETCs were implemented in the lower divertor and in the upper SAS divertor of DIII-D. • Heat flux components were quantified within the enclosed SAS-VW divertor. • Non-charged particles significantly contribute to divertor heating during detachment. • The heat flux from non-charged particles exhibited dependence on the direction of the ion grad-B drift. Surfacing Eroding Thermocouples (SETC) have been used to provide high spatial and temporal resolution heat flux measurement in DIII-D. SETCs were first tested in the lower divertor of DIII-D using the Divertor Material Evaluation System (DiMES), then an array of SETCS was permanently installed in the upper SAS-VW divertor for studying the heat flux mitigation in closed divertor geometry. SETCs proved that inducing divertor detachment with various methods is an effective way to reduce the peak heat flux at the divertor targets. In the investigated discharges the heat flux is reduced to less than 30% under detachment compared to attached conditions. A new method of using the combination of recessed SETC and flush SETC was demonstrated to be able to measure the heat flux from volumetric radiation and the charge exchange neutrals. It was observed that the magnitude of the heat flux from radiation and charge exchange neutrals increased during the process of detachment. While 30% of the total incident heat flux is attributable to the volumetric radiation and the charge exchange neutrals in the fully detached divertor condition with B × ∇ B drift into the divertor, it could reach more than 60% with B × ∇ B drift away from the divertor.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,007 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle