COMPLEX THERMAL INTEGRATION OF THE RECTIFICATION PROCESS OF THE BENZENE-TOLUENE MIXTURE
Pourquoi ce travail est dans la base
Une base qui oublie comment elle a trouvé un travail ne peut pas être vérifiée. Voici les voies qui ont admis celui-ci.
Notice bibliographique
Résumé
Comprehensive thermal integration of the benzene-toluene mixture rectification process was carried out. Thermal integration was carried out using pinch analysis methods with using thermocompression. The principle technological scheme of rectification of the benzene-toluene mixture with a productivity of 11 t/h is taken as a basis. For this performance, the consumption of flows, their temperatures, heat load, and flow heat capacities are calculated on the basis of the material and heat balance. Based on the calculated data, a flow table was created. Three hot streams are selected for integration: the distillate, the tailings, and the vapor from the top of the column, and two cold streams: the initial mixture and the column cube. The necessary degree of vapor compression is calculated for thermocompression. For a given degree of compression, the temperature of the steam after compression and the temperature of its condensation were calculated. Based on the technical and economic considerations, the minimum temperature difference DTmin=12 °С was determined for this technological scheme of the rectification process. For the selected DTmin, the component curves of the flows are constructed. Using the table algorithm method, the temperatures of the furnace for hot and cold flows were determined, which are ТНpinh=82 °С, ТСpinh=70 °С. The minimum number of hot and cold utilities is determined: QНmin and QCmin. For the selected DTmin, heat recovery was obtained in the amount of Qrek=2186,82 kW. A grid diagram is constructed, heat exchangers are located in accordance with CP and N rules. A technological scheme of the rectification process after reconstruction using thermocompression is proposed. The upgraded scheme includes the use of four recuperative heat exchangers, one heater and two coolers to achieve target flow temperatures. It is recommended to install a compressor for thermocompression. The use of Alfa Laval plate heat exchangers is proposed as heat exchange equipment. The payback period of the proposed solution is approximately two to two and a half years.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,000 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découle