Preliminary Numerical Analysis for a Naphtha Co-injection Test During SAGD
Bibliographic record
Abstract
Abstract and Introduction Steam Assisted Gravity Drainage (SAGD) is a steam-flood process that relies on thermal diffusion and gravity to mobilize bitumen in oil sands reservoirs and allow for recovery. A pair of parallel horizontal wells are drilled near the bottom of the pay zone with approximately 5 m vertical separation between them. After an initial circulation phase to establish communication, high quality steam is continuously injected down the injection well while the heated bitumen and condensate flow to the production well as a result of gravity. The volume of low oil saturation left behind is filled with steam and referred to as the steam chamber. The steam chamber grows vertically until it hits the cap-rock at which point it grows laterally away from the horizontal wells(1). A major cost of producing bitumen by SAGD is the energy required to produce steam; thus there is a great drive to improve the energy efficiency of a SAGD project. Solvent addition is expected to increase oil production and improve the energy efficiency of SAGD by combining the thermal process with the diluents mechanism of a solvent(2). A solvent is added to the steam chamber by injecting the solvent-steam mixture continuously from the injector well(3). Reservoir simulations of solvent-steam co-injection were done with a pseudo-compositional thermal reservoir simulator. The effects of co-injecting a multi-component solvent, naphtha, and a single component solvent, propane or pentane, were compared to SAGD. Three pseudo-components were used to model the multi-component behavior of naphtha. Co-injection of any of the solvents studied (propane, pentane, naphtha) resulted in an improved SOR. The greater the mole ratio of solvent to steam, the greater the improvement in SOR. Only naphtha co-injection resulted in an improved oil production rate. All components of naphtha travelled freely in the vapour chamber and accumulated along the vapour chamber front in both the vapour and oil phases. At higher solvent to steam ratios, the oil production rate decreased due to an accumulation of solvent gas at the vapour chamber front. Reservoir Model Description Simulations of a SAGD well pair were performed using a homogeneous, two-dimensional model of a vertical cross section perpendicular to the wells. Figure 1 shows the layout of the 100 m by 1 m by 20 m model made of 1 m cubes. Reservoir values typical to the MacKay River McMurray Formation were used and are listed in Table 1. The horizontal production well is in grid cell 50, 1, 18, and the horizontal injector is 5 m above the producer in grid cell 50, 1, 13. The model is bound on the top and bottom by impermeable cap and base rock. No mass or heat transfer can occur through the two other side boundaries of the model. The numerical models considered in this paper provide a preliminary analysis of the complex, three-dimensional system that is expected to exist in reality(4). The following assumptions were made in the course of the numerical study:Bitumen is modeled as "dead " oil, existing only in the oil phase;Water and oil are immiscible;
Fetched live from OpenAlex and de-inverted. Abstracts are not stored in this database: the inverted indexes are 8.6 GB of the frame’s 9.3 GB of text, and the host has 13 GB free.
How this classification was reachedexpand
Full frame distilled prediction
Teacher imitationNot calibrated prevalence, not ground truth. Human validation pending. Learned from the 10,348 direct Codex labels and 10,348 direct Gemma labels. Candidate is the union of thresholded teacher heads; consensus is their intersection. These outputs are machine_predicted_unvalidated and are not human labels or direct frontier model labels.
Codex and Gemma teacher scores by category
| Category | Codex | Gemma |
|---|---|---|
| Metaresearch | 0.000 | 0.000 |
| Meta-epidemiology (narrow) | 0.000 | 0.000 |
| Meta-epidemiology (broad) | 0.000 | 0.000 |
| Bibliometrics | 0.008 | 0.002 |
| Science and technology studies | 0.000 | 0.000 |
| Scholarly communication | 0.000 | 0.000 |
| Open science | 0.000 | 0.000 |
| Research integrity | 0.000 | 0.001 |
| Insufficient payload (model declined to judge) | 0.000 | 0.000 |
Machine scores (provisional)
The two teacher heads of the student model, read on this work. A score orders the frame for review; it never asserts a category, and the validation status ships verbatim with every row.
Baseline scores from an immature model (maturity gate not passed, 7 training rounds). Scores rank; they never assert a category.
score_only:v0-immature-baseline · verbatim from the scoring run: score_only means the number may rank works, and no category label ships from itClassification
machine, unvalidatedMachine predicted; a candidate call from one teacher head, not a consensus.
How this classification was reached, model by model and score by score, is at the end of the page under "How this classification was reached".