Why this work is in the frame
A frame that forgets how it found something cannot be audited. These are the routes that admitted this work.
Bibliographic record
Abstract
In February 2014, owing to heavy snowfall in the Kanto-Koshin region, several buildings were severely damaged. A major cause for the damage was the load on building surfaces caused by heavy snow followed by a surcharge load due to the ensuing rainfall. Countries such as the United States and Canada have established standards on snow loads, which also take into account the surcharge load due to rainfall. In contrast, Japan has not adopted such standards, and hence it is imperative to establish a method for calculating loads added by rainfall to snow loads. Therefore, in this study, experiments were conducted using artificial rainfall on roofs covered with snow to evaluate and propose a calculation method for loads added by rainfall.<br> First, outdoor experiments as well as indoor experiments in a low-temperature experimental facility were conducted. Model roofs with different span lengths and gradients were built and loaded with natural and artificial snow. These model roofs were then treated with rainfall at constant intensity by using an artificial rainfall simulator. The increase in load was measured and several observations were made from the experiments. A smaller roof gradient and larger roof span resulted in a greater peak value of the load added by rainfall. For roofs of the same shape, the peak value of the load added by rainfall increased as the initial snow depth increased. Next, the relationship between surcharge loads due to rainfall and the span length and gradient of the roofs was quantified. The load added by the rainfall was treated as the approximate square root of the snow depth, and a coefficient a, which depends on the span length and gradient of the roof, was defined. However, valuable data were obtained from the experiments for only five types of roof geometries. To estimate the values of the coefficients a for other roof geometries, regression analysis between the coefficient a, roof gradient, and span length was conducted. Comparing the surcharge loads, which were calculated using the estimated coefficients a, with the loads calculated using the O'Rourke equation, a relatively good correspondence between both the results was confirmed.<br> Snow loads that take rainfall into account were obtained for the given regions with corresponding values of the design snow depth. This was achieved by including the load due to rainfall, which is correlated to the snow depth, computed from the proposed formula and the estimated coefficients. In addition, methods that include coefficients reflecting the regional climatic conditions were proposed. One such method is based on the fact that winter rainfall is not always observed during the period when the deepest snow cover occurs. Extreme values of the snow depth were obtained from the meteorological data to derive the ratio of snow loads on rainy days against the maximum winter snow loads; the ratio was treated as the coefficient k1. Another method considers the regional meteorological cases wherein the surcharge load due to rainfall does not reach the peak value. The ratio of the surcharge load value due to such rainfalls against the surcharge load calculated by the proposed formula was treated as the coefficient k2. However, because the influence of coefficient k2 is relatively small, it can be considered as 1 in practice. Moreover, because the impact of loads added by rainfall is relatively small in heavy snowfall regions, the regions where it is necessary to consider the loads due to rainfall may be limited to general regions where the design snow depth is 1 m or less.
Fetched live from OpenAlex and de-inverted. Abstracts are not stored in this database: the inverted indexes are 8.6 GB of the frame’s 9.3 GB of text, and the host has 13 GB free.
Full frame distilled prediction
Teacher imitationNot calibrated prevalence, not ground truth. Human validation pending. Learned from the 10,348 direct Codex labels and 10,348 direct Gemma labels. Candidate is the union of thresholded teacher heads; consensus is their intersection. These outputs are machine_predicted_unvalidated and are not human labels or direct frontier model labels.
Codex and Gemma teacher scores by category
| Category | Codex | Gemma |
|---|---|---|
| Metaresearch | 0.001 | 0.000 |
| Meta-epidemiology (narrow) | 0.000 | 0.000 |
| Meta-epidemiology (broad) | 0.000 | 0.000 |
| Bibliometrics | 0.001 | 0.003 |
| Science and technology studies | 0.001 | 0.001 |
| Scholarly communication | 0.000 | 0.000 |
| Open science | 0.001 | 0.001 |
| Research integrity | 0.000 | 0.002 |
| Insufficient payload (model declined to judge) | 0.000 | 0.000 |
Machine scores (provisional)
The two teacher heads of the student model, read on this work. A score orders the frame for review; it never asserts a category, and the validation status ships verbatim with every row.
Baseline scores from an immature model (maturity gate not passed, 7 training rounds). Scores rank; they never assert a category.
score_only:v0-immature-baseline · verbatim from the scoring run: score_only means the number may rank works, and no category label ships from it