Investigations of Interfacial Coupling Phenomena and its Impact on Recovery Factor
Notice bibliographique
Résumé
Abstract Interfacial coupling phenomena in multiphase-flow through porous media, and its impact on the recovery factor, have been of interest for sometime, especially in the SAGD process and in fractured reservoirs. In this study, a numerical simulator that takes into account inlet end effects was developed to solve the modified transport equations proposed by Bentsen1,2, Ayub and Bentsen3, and Ayub4 and Ayodele5 to account for interfacial coupling phenomena and hydrodynamic effects. Moreover, the simulator was validated using experimental data. Finally, sensitivity analysis studies were carried out with the simulator to show the effect of interfacial coupling phenomena on the recovery factor. Introduction It is well known that Darcy's equation was developed onthe basis of experiments involving single-phase flow through porous media. To account for multiphase flow, Darcy's equation was modified by Muskat et. al. 6 into a form that has been widely used in petroleum reservoir engineering. However, as pointed out by several researchers1,3,7–13, the modified equation can not give accurate recovery predictions when used to simulate multiphase flow in petroleum reservoirs. This is because, in multiphase flow, the presence of one fluid affects the flow of the other fluids; that is interfacial coupling effects (viscous and capillary coupling effects) influence the flow. The viscous coupling effect, first identified by Yuster14, refers to the coupling that arises due to the viscous drag exerted by one fluid on the other when they flow through the same porous medium, and it is usually associated with the mobility of the fluids5. The capillary coupling effect, recently postulated by Babchin and Yuan15 and by Bentsen16, refers to the coupling that arises due to coupling, through the capillary function2, of pressure across the interfaces of the fluids. Moreover, counter-current experimental data17–19 has been used to show that Muskat's extension of Darcy's equation does not correctly describe the physics of multiphase flow through porous media, because the magnitude of the relative permeabilities for a given phase obtained from counter-current flow is always less than that acquired from a co-current experiment conducted in the same porous medium. To closely capture the physics of flow, Bentsen1,2, Ayub and Bentsen3, Ayub4 and Ayodele5 developed a set of modified transport equations that incorporate interfacial coupling and hydrodynamic effects. In the following sections, a one dimensional form of these modified transport equations is solved numerically by developing an Interfacial Coupling Simulator (ICS), simulation results are compared with immiscible displacement experimental data and some conclusions are drawn as well. Mathematical Formulation To describe the one dimensional immiscible displacement flow by using the fractional flow concept, two governing equations, the fractional flow equation and the frontal advance equation, are needed. Fractional Flow Equation With the assumption that two immiscible and incompressible fluids flow through a homogenous and isotropic water-wet porous medium, Bentsen1,2, Ayub and Bentsen3, Ayub4 and Ayodele5 developed a set of modified transport equations whose one dimensional form is as follows: (Equation 1) (Available in full paper) (Equation 2) (Available in full paper)
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,000 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule tête enseignante, pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».