Migration of Fine Solids into Product Bitumen from Solvent Extraction of Alberta Oilsands
Notice bibliographique
Résumé
The extraction of bitumen from the oilsands using solvents has the potential to avoid the environmental problems with wet tailings associated with water-based extraction technology. One of the key performance parameters for this technology is the concentration of fine solids in the recovered bitumen. In this study, the concentration and properties of the fine solids in cyclohexane-extracted bitumen were examined as a function of the water content of the ore. Total water contents from 3.4–13.4 wt % gave the lowest concentrations of fine solids in the bitumen, ca. 0.2 wt % of the initial mass of a low-fines content ore. Higher fine solids contents in the bitumen were observed with water concentrations outside this range and with higher concentrations of fine solids in the initial oilsands ore. The fine solids exhibited a distribution of surface properties, and the most hydrophobic, carbon rich solids were carried into the bitumen even under the most favorable conditions. When the bitumen was more contaminated with fine solids, due to higher fines in the ore or lack of water to bind the fines to the sand, the carbon content of the fine solids decreased. The majority of the carbon in the fine solids was organic material due to bitumen and surface adsorbed components. Despite carbon contents over 20 wt %, XPS analysis showed significant surface silicon and aluminum, and contact angles were in the range of 80–88°, consistent with partial organic coating of the mineral particles. Characterization of the fine solids by SEM, particle size, and mineralogy suggested that the migration of the fine solids into the bitumen, versus remaining with the coarse sand, was significantly affected by the organic surface deposits on the particles.
Récupéré en direct depuis OpenAlex et désinversé. Les résumés ne sont pas conservés dans cette base de données : les index inversés représentent 8,6 Go des 9,3 Go de texte de la base, et le serveur dispose de 13 Go libres.
Comment cette classification a été obtenuedéplier
Prédiction distillée sur la base complète
Imitation des enseignantsNi prévalence calibrée, ni vérité terrain. Validation humaine à venir. Apprise à partir de 10 348 étiquettes directes de Codex et de 10 348 étiquettes directes de Gemma. Le mode candidate est l'union des têtes enseignantes seuillées; le consensus est leur intersection. Ces sorties portent le statut machine_predicted_unvalidated et ne sont ni des étiquettes humaines ni des étiquettes directes de modèles de pointe.
Scores Codex et Gemma par catégorie
| Catégorie | Codex | Gemma |
|---|---|---|
| Métarecherche | 0,000 | 0,000 |
| Méta-épidémiologie (sens strict) | 0,000 | 0,000 |
| Méta-épidémiologie (sens large) | 0,000 | 0,000 |
| Bibliométrie | 0,000 | 0,000 |
| Études des sciences et des technologies | 0,000 | 0,000 |
| Communication savante | 0,000 | 0,000 |
| Science ouverte | 0,000 | 0,000 |
| Intégrité de la recherche | 0,000 | 0,000 |
| Charge utile insuffisante (le modèle a refusé de juger) | 0,000 | 0,000 |
Scores machine (provisoires)
Les deux têtes enseignantes du modèle étudiant, lues sur ce travail. Un score ordonne la base pour la relecture; il n'affirme jamais une catégorie, et le statut de validation accompagne chaque rangée tel quel.
Scores de référence d'un modèle non mature (critères de maturité non atteints, 7 itérations). Un score ordonne; il n'affirme jamais une catégorie.
score_only:v0-immature-baseline · tel quel depuis la passe de notation : score_only signifie que le nombre peut ordonner les travaux, et qu'aucune étiquette de catégorie n'en découleClassification
machine, non validéePrédiction automatique; un appel candidat d’une seule tête enseignante, pas un consensus.
Le détail, modèle par modèle et score par score, se trouve en fin de page sous « Comment cette classification a été obtenue ».